Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

  • fmstrat@lemmy.nowsci.comOP
    link
    fedilink
    English
    arrow-up
    4
    arrow-down
    1
    ·
    5 months ago

    Yea, planning to give it a try. I just found the settings in .local/share/cura so that’s at least a good thing, but what a headache.