Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.
Comon, do some reading:
Do some comprehending. Yes he had to do that. But it was because he was using the wrong bit.
Phone camera; $30 digital microscope; $30 Endoscope. There are just so many better ways available to look down a hole to see what’s at the bottom than to tear apart the space around it.
OP didn’t have to handle it how they did, at all.
He had to see which bit to use
Phone camera; $30 digital microscope; $30 Endoscope. There are just so many better ways available to look down a hole to see what’s at the bottom than to tear apart the space around it.
That can be accomplished non-destructively.