The lack of banding and wobble is excellent, especially compared to where you came from. You’ve got me thinking about a new extruder. I’ve got some no name aluminum extruder setup right now, but I’ve put enough abrasive filament through that it’s made all my filament paths oblong.
Nice work!
Operation Sea Spray
COINTELPRO
MK Ultra
Now that’s some class solidarity.
It’s not all theHill’s fault, there’s plenty of blame to go around.
They didn’t even push back against the reactionary talking points from the looks of it. The primary argument mentioned is “states’ rights.”
It’s the same thing they’ve been doing with immigration, conceding every single point, until they eventually are running on “bipartisan legislation to address the issues!” That consists of all the Republican talking points from eight years ago.
Democrats hated “the gays” too until like 15 years ago.
It’s the same as rainbow corporatism. It’s all a facade used for political expediency. It’s never actually about human rights. Both parties deserve the fates they get. Unfortunately they’ll do everything they can to take us down with them.
I’ve got one and they’re safe enough to visit any shipwreck.
I took mine to the bottom of the Mariana Trench.
Only wusses don’t hop on and immediately go as deep as possible.
I’m marking this thread as “No Reply”
Take that, voters.
The only place I know to get it is direct from their site.
I’m not sure that you do, as far as I know, being able to move them is the only test. I’m printing a torture toaster now to see if I’m getting similar results with that. I know there are more precise ways to measure dimensional accuracy, but I’ve always been able to print a decent benchy and calibration cube. Actual applications have been less successful.
NYT is and always has been a pro-violence mouthpiece for capital.
They’ve accidentally done some good journalism here and there but I’m hard pressed to find it right now.
But it can when they take it through the car wash after lol
I feel you, but the reality is probably more like “Project Manager said I need to save 13 more cents on materials or he’ll murder my children, so if I move the oil filter from this nice easy to access location and remove the lip that catches any drippage it’ll get us there.”
90% of the time it’s the bosses.
Is your upright the one with all the little compartments? That one looked to me like the most efficient upright design I’ve ever seen.
They’re pissy cause it being open source and more efficient means that it’s gonna be more cost effective for people to use. Which is real bad if your company overcommitted to the slop and needs to recover losses.
These are some of my favorites, I’m sure I’m missing some though.
Cancer grows continuously. Obviously we should model everything on that.
Yeah… That’s really weird.
Maybe they were bleaching the well. Double check your well cap?
I understand that stance for sure. My border proximity is less for running because of rights restrictions and more based on the necessity for humanitarian aid if things get too spicy. I arrived at a similar conclusion about where Canada, and the rest of the Western world to be frank, is going. We just tend to lead the pack on things like modernizing fascism here in the US.
Leaving Missouri for Minnesota has done loads for the mental health of myself and my family. I cannot recommend this place enough especially if you’ve mostly only experienced states run by people who think that governments can’t actually do things.
I did print myself a herome mount and everything awhile back. Added dual fans and whatnot, I was having a terrible time with petg surface quality, the dual fans helped a lot. I also had to reassemble my hotend to reprint something I messed up lol.
I’m at the point now where I’ve replaced so much on my ender that it doesn’t really look like the machine I bought, except that it’s still i3.
I’ll check out the orbiter, thanks!