Clamp & glue is plenty strong. I’ve built a couple of desks with this approach plus a large dining table.

My cats would have loved to use the top as a scratching pad! Look out 😅

Nice work on the wrapping, it looks very clean.

Could you swap out the back legs with longer ones to help the thigh clearance?

Check the calibration:

1. Confirm that the outfeed table is parallel to the cutter head.
2. Confirm that the outfeed table is level with the top dead center of the cut.
3. Then confirm that the infeed table is parallel to the outfeed
4. Lastly confirm that the fence, when set to 90, is square to the outfeed table.

This should all the the case right out off the pallet but it’s worth a check.

I relief on polled notifications from Sync. Worked just fine for me.

Awesome! Thank goodness the kiddos like the set.

Dust collection is a great application for 3D printing… Years ago I broke the bag adapter for my sanding station so I made a replacement!

I’d go with an oil-based polyurethane. Stain is your choice. While water based poly will have much less odor I’ve found it to be less durable.

Oil based poly will smell much much worse than shellac. Water based poly wouldn’t be so bad.

Oh yeah… And be sure to never let your filament get tangled!!! Google that before you get started 😂

Exciting stuff! Good luck with the move.

I’m doing basic, functional stuff so there’s thankfully not much to figure out. I haven’t done any mods to my printer. The bed stays level as long as I’m gentle while removing the print.

The only thing I’ve struggled with was layer and bed adhesion during cold weather. To solve that I made a simple enclosure and also slowed down my first layer.

I’m fairly satisfied with AccuWeather. Not as good as Dark Skies was but close!

Mitered dovetails?

How handy is that? You can just bring along the old one to make sure the slots will agree.

https://www.leevalley.com/en-us/shop/tools/hand-tools/planes/blades/42607-stanley-record-bench-plane-blades-made-by-veritas?item=05P3123

I think you’ll be able to judge if it would work. This iron will be a tad thicker but that’s not a problem.

Ah, so for the carousel you oriented the tiles vertically on a large circle?

Try Lee Valley, they offer irons in a variety of widths.

How did you make the curved tiles?

How does the cane attach to the door frame?