deepfriedchril

The steam deck apu isn’t even top of the line.

Just opposite of the current position. Would only apply to views where thumbnails can be on one side of course (small, smaller, compact)

It would be nice to have a quick action to change thumbnails to the opposite side.

It depends more on how much time you want to spend on post processing and how detailed the part is. Teller layers means more time spent filling and smoothing.

You can print at .2 layer height with a .6 noz and benefit from a thicker line width, giving you stronger parts but the overall time to print will still be similar compared to a .4 noz.

If your options are limited, it might be helpful to list them.

I actually started listening to his Avalon album again, so good.

+1 for display fusion.

Don’t rule out the wire behind the dash. I was experiencing similar behavior until my phone just didn’t connect but still was getting power from the port. Turns out the wire connecting the USB port and the head unit was faulty. If I wiggled the wire on the end connected to the head unit then it worked like normal.

TIL I’ll have to check on those other clients too, thanks p

No sponsor block in ff though?

Food Wishes is the GOAT.

Please provide measurements.