The amount of waste and time it takes are downright insulting

That’s capitalism - it’ll gladly sell you even its own criticism

I did, check my comment.

Completely new and dried for 24 hours in a dedicated dryer. Thanks.

SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

Yes, this is probably adding to the situation.

I don’t want to have to enter password when I’m accessing my Proxmox admin when I’m home. That’s it :)

I’m in the same boat. I’d like to have something like this integrated with Home assistant but Grocy is just ludicrously complex. It’s like SAS for your fridge, only more complex. With rude developers who always know better than everyone else.